Set to 47 for direct drive motor, 100 for geared motors. Correct wheel size is required for accurate speed and odometer function. Sets the wheel size of the bicycle in inches. More levels = finer control over amount of assistance given by the motor. Sets of the number of Pedal Assist System (PAS) levels available. Used to calibrate battery level indicator.Ġ-60 minutes, 0 disables inactivity timeout.Īutomatically sets display/controller to sleep after a given time of inactivity. This should match the output of your battery. Sets the displayed unit of measurement for odometer and speed. Parametersīrightness of the display in low light (night). Press and hold the UP and DOWN arrows at the same time for about 5-6 seconds to exit configuration menuĪfter 10 seconds of inactivity, configuration will automatically be saved and exited. Short press M button to navigate between parameters (P01-P16). Parameter value will be present the odometer section. Parameter P01 will show up on the screen below in the speed section. Press and hold the UP and DOWN arrows at the same time for about 5-6 seconds to enter configuration menu. Hold the M button pressed for 5-6 seconds to turn the LCD Display On and Off.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |